Arcam RCUBE Betriebsanleitung PDF herunterladen (Seite 14)

Operate

E-14

Playing from a Line-Level Source

Connect the line level source to AUX-in

Line level sources (e.g. a CD player or

preamplier output) typically have RCA phono

connectors (pictured at right) and they do not

usually have any volume control. To connect

a line level source you will need a cable that

has dual (le and right) RCA phono male

connectors on one end and 3.5mm stereo

mini-jack on the other. If there is a volume

control on the source set it to 90%. Make this

connection with the unit switched o.



Power up

Plug one end of the power supply into the AC

mains wall supply and the other into the DC power input

jack on the rear panel of the rCube. Switch the rCube on

by pressing its power rocker switch on the rear panel, the

front LED will glow red (standby mode). Press the standby

button on the top panel or on the remote. e power LED

will change from red to blue and the rCube is now on.

Select AUX-in as the source

Press the ‘Source Select’ button on the remote control or

press the source button on the top panel until the source

LED turns red. Red indicates AUX is chosen as the source.

Make sure the external source is playing

Use the controls on the line-level source to start playback

and verify the device is playing.

Adjust volume

Use the + and - volume buttons on the remote or on the

top panel to adjust the volume to desired level.

Line-Level

Source

SERIAL NO

CD OUT

SERIAL NO

Dig tal

Note: some devices output line level from

a 3.5mm stereo mini jack. If you have one

of these you will need a stereo male to male

3.5mm cable instead of the one shown.







1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Arcam RCUBE Betriebsanleitung Seite 14

Kommentare zu diesen Handbüchern